[. . . ] â· Do not apply excessive force when connecting or disconnecting the BR-1. Read this manual thoroughly before use and keep it handy when using the product. This barcode reader unit is for use exclusively with RICOH G700SE cameras. [. . . ] The scan direction should be at Correct a right angle to the lines in the barcode. Do not touch the internal components of the equipment if they become exposed as a result of being dropped or damaged. Cease use immediately and take the product to the point of purchase or to one of the RICOH service centers listed in the camera manual. Do not use the equipment near flammable gases, gasoline, benzene, thinner or similar substances to avoid the risk of explosion, fire or burns. Do not use it in a high temperature environment such as next to a fire or inside a car, or abandon it. Radio-frequency interference emitted by this device could cause accidents. Follow the directions of hospital staff when using this device in the vicinity of medical equipment. See "Software User Guide" supplied with the camera for more information on using barcodes. *1 MRD 90% *2 / The widths of the gaps between barcode characters are the width of a narrow bar. When the BR-1 is attached, the camera can only be used to read password barcodes. Laser Safety This machine complies with the requirements of IEC60825-1:2007 (EN60825-1:2007)/IEC60825-1:1993+A1:1997+A2:2001 for class 1 laser product. Or Caution: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Caution: Be careful not to dislodge the clock battery (circled) when connecting or disconnecting the BR-1. Rapid changes in temperature could cause condensation inside the device, resulting in rust or mold. [. . . ] Insert the connector on the BR-1 (b) into the connector on the camera with the read button (c) and status lamp (d) at the rear of the camera (Step 2). 3 Attach the BR-1 to the camera using the two screws (f ) supplied with the BR-1. Insert the long shaft of the Allen key into the head of the screw and rotate the short shaft by hand to tighten the two screws (Step 3). [. . . ]